Four initiating zones (expandable to eight) with up to 20 two‑wire smoke detectors per zone
Programmable through keypads or remote programming software (RPS) through a Conettix interface module
Two notification appliance circuits (NACs) on board with a shared internal regulated 24 VFWR, 4 A NAC power supply
Easily converts to addressable with the addition of a MUX expansion module
Reports to two phone numbers, two IP addresses, or a phone number and an IP address
| Line impedance for ground fault detection (Option Bus, conventional input, NAC, secondary power circuit, MUX Bus, AUX power, SMK power) | 10kΩ |
| Power (Input) | 120V 60Hz 1.4A or 230\240V 50Hz, 0.7A |
| Power (Auxiliary) | 17 to 31VFWR, unfiltered, 1.0A |
| Power (Smoke)1 | 20.4 to 28.2VDC nominal, filtered, 1.0A. |
| Power (Option Bus) | 12VDC nominal, 500mA |
| Power (Notification Appliance Circuit [NAC])2 | Each NAC has 24VFWR nominal, unfiltered power with up to 2.5A capacity (but limited by overall 4.0A capacity) |
| Power (Optional Standby Batteries) | Two 12V (in series), 7Ah to 40Ah |
| NACs Line Impedance (voltage loss) | 1.5V |
| Recommended Manufacturers3 | Power Sonic: PS-1270, PS-12170, PS-12180YUASA: NP7-12, NPG18-12 |
| 1 For compatible smoke detection devices, see also the FPD‑7024 Smoke Detector Compatibility List.2 For compatible NAC devices, see also the FPD‑7024 NAC Compatibility List3 If other manufacturers or battery types are used, ensure that the battery or batteries can handle an initial charge current of at least 1.7 A. | |
| Temperature (operating and storage) | +32°F to +120°F (0°C to +49°C) |
| Wiring | ClassB or ClassA |
| Notification patterns | Configurable for steady, pulsing, California March, Temporal (ANSI) code 3, synchronized Wheelock, synchronized Gentex, and synchronized System Sensor. |
| Local (on-board) | The main control panel includes Three FormC relays. The relay contacts are rated at 5A, 28VDC. No over current limiting is performed on the contacts of the relays. The default selection for the relays is to indicate general alarm (relay 1), general system trouble (relay 2), and supervisory (relay 3). By using point or zone mapping, they can be programmed to activate in a wide variety of conditions. |
| Remote1 | Eight Form C relay outputs are provided by a D7035 Remote Relay Module. The module connects to the FPD‑7024 through the option bus. The outputs are fully programmable, exactly as the local relays are programmed. Each output operates independently of the other seven to provide complete flexibility. Communication with the D7035 is supervised. Contact Rating: 5A at 28VDCNumber of Modules: two units maximum. |
| 1 For wiring requirements, see Option bus wiring requirements. | |
B426 以太网通信模块
支持通过Ethernet网络与兼容的报警主机进行双向通信
商业类型： B426
产品编号： F.01U.324.383
B450 插入式通信装置接口
支持使用适合兼容报警主机的插入式蜂窝通信装置进行双向IP通信
商业类型： B450
产品编号： F.01U.323.797
D126 电池，12V 7Ah
A rechargeable sealed lead‑acid power supply used as a secondary power supply or in auxiliary or ancillary functions.
商业类型： D126
产品编号： 4.998.125.825
D7030X 显示盘，8个报警LED
Eight zone LEDs indicate alarm conditions.
商业类型： D7030X
产品编号： 4.998.800.536
D7030X-S2 信号器，8个LED（2个用于监控）
Two LEDs indicate supervisory conditions, six indicate alarm conditions.
商业类型： D7030X-S2
产品编号： 4.998.140.386
D7030X-S8 信号器，8个LED（8个用于监控）
All eight zone LEDs (yellow) indicate supervisory conditions.
商业类型： D7030X-S8
产品编号： 4.998.140.387
D7032 信号器扩展器，8个LED
Use with D7030X Family LED annunciators
商业类型： D7032
产品编号： 4.998.140.388
D7035 多路传输八进制继电器模块
Provide eight Form C relay outputs (w/o enclosure) for the D7024, FPD-7024, or FPA‑1000 Fire Alarm Control Panels (FACP)
商业类型： D7035
产品编号： 4.998.800.539
D7039 多路传输扩展模块
The D7039 enhances the conventional features of the D7024 or FPD‑7024 FACPs by increasing the number of addressable points to 256, the number of relay outputs to 58 on the D7024 or 59 on FPD‑7024, the number of events on the history buffer to 499, and the number of users to 100.
商业类型： D7039
产品编号： 4.998.800.529
D7042 远程模块，8输入，B类
Board and plastic enclosure with spring tamper
商业类型： D7042
产品编号： 4.998.800.552
D7044 多路传输单一输入模块，12V
The module connects a normally‑open (NO) contact to the multiplex bus of an FPD‑7024, D7024, or DS9400 FACP. The module draws supervised input power from the FACP for use in a ClassB configuration. Rotary switches allow convenient address setting.
商业类型： D7044
产品编号： 4.998.800.545
D7044M 多路传输迷你单一输入模块，12V
Connects a normally‑open (NO) contact to the multiplex bus of an FPD‑7024, D7024, or DS9400M FACPs.
商业类型： D7044M
产品编号： 4.998.800.546
D7050 多路传输感烟头
The symmetry of the D7050’s optical chamber allows 360° uniform smoke entry, but minimizes external light entry. Within the chamber, large smoke particles scatter infrared light which is detected by a gated, high-speed, photodiode sensor.
商业类型： D7050
产品编号： 4.998.140.391
D7050TH 多路传输火灾探测器头，固定热量
The D7050TH has an optical smoke chamber and a 35°F (57°C) fixed-temperature sensor. Use it in confined areas where a fire increases air temperature slowly but substantially before the fire breaks confinement.
商业类型： D7050TH
产品编号： 4.998.140.394
D7050-B6 多路传输底座，2线
Required base for the D7050 and D7050TH MUX smoke heads
商业类型： D7050-B6
产品编号： 4.998.140.392
D7052 多路传输双输入模块，12V
Connects normally‑open (NO) contacts to the multiplex bus of an FPD‑7024, D7024, or DS9400M FACP
商业类型： D7052
产品编号： 4.998.800.549
D7053 多路传输输入/输出模块，12V
Connects normally‑open (NO) contacts to the multiplex bus of an FPD‑7024, D7024, or DS9400M FACP in configures as either ClassA or ClassB configuration
商业类型： D7053
产品编号： 4.998.800.550
DX4010V2 USB/串行接口模块
旨在兼容控制主机与经认可的应用程序之间提供本地连接。
商业类型： DX4010V2
产品编号： F.01U.080.969
FMM-7045 多路传输手动操作器，单个，红色
The single‑action manual station is UL listed and meets Americans with Disabilities Act (ADA) requirements. An address on the polling circuit is easily set with rotary switches. The pull-down handle locks in the activated position. It is reset by opening the unit with a key and then relocking it.
商业类型： FMM-7045
产品编号： F.01U.001.461
FMR-7033 LCD信号器和控制显示盘
Combines remote annunciator and controller functions for fire alarm systems controlled by an FPD‑7024 Fire Alarm Control Panel
商业类型： FMR-7033
产品编号： F.01U.009.157
FMR-7036 LCD信号器显示盘
Four‑wire LCD annunciator keypad used with the FPD‑7024 Fire Alarm Control Panel to establish the location of a fire alarm
商业类型： FMR-7036
产品编号： F.01U.009.156
FPC-7034 IDC扩展器，4点
The FPC‑7034 adds four ClassB or two ClassA initiating circuits to the FPD‑7024 FACP. This plug‑in module is automatically recognized by the control panel's firmware when power is restored to the system.
商业类型： FPC-7034
产品编号： F.01U.003.861
FPE-7039 多路传输扩展模块，适用于FPD-7024
It enhances the features of the FACPs. It increases the number of addressable points to 247. It increases the number of relay outputs to 58 on the D7024/DS9400 or 59 on the FPD‑7024. It increases number of events on the history buffer to 499.
商业类型： FPE-7039
产品编号： F.01U.299.029
FPP-RNAC-8A-4C 火灾报警控制器
When connected to a panel’s option bus, the FPP-RNAC-8A-4C adds four additional NFPA72, ClassB or ClassA NACs. When connected directly to the NAC output, it is also a NAC power supply for fire-protective signaling systems.
商业类型： FPP-RNAC-8A-4C
产品编号： F.01U.003.444
ITS-DX4020-G GPRS/GSM集成式通信装置
Digital cellular communicator used for two-way IP or dialed communications over GPRS/GSM networks.
商业类型： ITS-DX4020-G
产品编号： F.01U.082.094
上海市长宁区虹桥临空经济园区福泉北路333号203幢8楼
(联系就说在DAV音视工程网上看到的)
communication@cn.bosch.com
021-2218 2569
博世（上海）安保系统有限公司（BOSCH）是全球领先的安防、会议和广播产品研发、制造、服务商及相关解决方案与服务的提供商。博世Bosch安防通讯产品线覆盖博世Bosch视频监控、博世Bosch入侵报警系统、博世Bosch会议系统、博世Bosch公共广播和语音报警、博世Bosch火灾报警系统、博世Bosch门禁控制系统、博世Bosch软件产品等。博世智能建筑科技稳立潮头，一直引领着这些新技术的发展。
DAV首页